Toot

Written by Ryan on 2025-01-08 at 19:46

I have one last design change I'm considering for the battery case.

Currently it's printed in six separate pieces, which are then paired into three cases. Each case has half a hinge on either side that gets fastened to its neighbor to make a full ring.

Now I could make the hinges print in place, resulting in two assemblies that print in place. But that would force it to print flat on the bed, and each individual piece already has a lot of surface area, so it sticks to the bed until cooled...

=> More informations about this toot | View the thread | More toots from yantor3d@mas.to

Mentions

Tags