The results are .... interesting.
The model printed at an angle was much easier to remove - too easy, in fact. The supports are better adhered to the bed than they are to the model.
The model printed at an angle has a uniform outer surface. The lower edge has some defects that could be remedied with additional support fins. There may be some droop in the holes and slots but they are still within tolerances.
[#]3dprinting
=> View attached media | View attached media
=> More informations about this toot | View the thread | More toots from yantor3d@mas.to
=> View 3dprinting tag This content has been proxied by September (3851b).Proxy Information
text/gemini