Toot

Written by Ryan on 2024-11-10 at 03:13

After five and a half hours, the first full scale test is ready. And there are notes.

To accommodate using battery clips instead of a modeled holder and a nickel strip tail, I had to increase the thickness to 36mm. Now it barely fits between the spokes.

But, I was able to get in on and off with two of the three hinge pins in, which is good.

When the clips arrive on Tuesday I'll iterate on the thickness - I may have to use 21700 cells instead of 26650 cells.

[#]bikeTooter #3dprinting #diy

=> View attached media | View attached media

=> More informations about this toot | View the thread | More toots from yantor3d@mas.to

Mentions

Tags

=> View diy tag | View 3dprinting tag | View BikeTooter tag