@FreeCAD project complete! The camera housing was easy enough, but the mounting bracket was a real challenge. I used a spreadsheet to specify the tilt and pan angles of the bracket. Getting it to update everything without errors as I adjusted these angles took some thinking in how to design it. The assembly workbench again proved very buggy. In the end I avoided multiple cylindrical joints and aligned as much as I could using adjacent faces, which the solver appears to cope with better.
=> More informations about this toot | More toots from drfootleg@fosstodon.org
@FreeCAD The bracket prints without the need for supports. It is not symmetrical. This one has a tilt angle of 46 degrees and a pan angle of 2 degrees to the left.
=> More informations about this toot | More toots from drfootleg@fosstodon.org
@FreeCAD Camera mounted on the #Voron Trident.
=> View attached media | View attached media
=> More informations about this toot | More toots from drfootleg@fosstodon.org
@FreeCAD Here you can see the view through the camera. I placed a couple of test prints on the bed to see where the limits of the field of view are. #3dprinting
=> View attached media | View attached media
=> More informations about this toot | More toots from drfootleg@fosstodon.org This content has been proxied by September (ba2dc).Proxy Information
text/gemini
