Ok #HomeAutomation folks, I would like some advice. I have some lighting circuits I want to smarten up. I have at my disposal Lutron Caseta, zwave, and zigbee.
A few of these circuits are single switch but most of them are multi-switch, either two or three each. I want to use accessory switches rather than the existing three/four ways because the four way switches are literally popping out of the front of the box.
What's my best option? Install the handful of zwave switches I have on hand as a way to move forward? Or should I drop $$$$ on Lutron gear? Or something else?
=> More informations about this toot | More toots from zrail@hachyderm.io
Follow up: I put an on/off zwave switch I had in stock on a single-switch light and it works great. Only problem is the 4-gang box is very tight so if I want to put more in there (which I do) I'm going to have to get some of the easy-fit switches.
[#]HomeAutomation
=> More informations about this toot | More toots from zrail@hachyderm.io
text/geminiThis content has been proxied by September (3851b).