Ancestors

Written by freeformz 🏳️‍🌈 on 2025-01-01 at 21:46

Next #PrusaXL Enclosure Install Step:

Upgrade Nextruder x 5

I may put this off until tomorrow.

sort of tired of futzing around with the printer atm.

=> More informations about this toot | More toots from freeformz@hachyderm.io

Toot

Written by freeformz 🏳️‍🌈 on 2025-01-02 at 21:27

It is done #PrusaXL

=> View attached media

=> More informations about this toot | More toots from freeformz@hachyderm.io

Descendants

Written by freeformz 🏳️‍🌈 on 2025-01-02 at 23:06

This is more of an "enclosure" than an enclosed printer.

Tons of gaps all over the place.

With negative pressure from the fan it should at least help with particles and the like.

#PrusaXL

=> More informations about this toot | More toots from freeformz@hachyderm.io

Written by Jeff Noxon on 2025-01-02 at 21:33

@freeformz That's pretty. I keep thinking about building a Voron with a toolchanger... something a bit smaller.

=> More informations about this toot | More toots from jeff@noxon.cc

Written by Jordan Sissel on 2025-01-02 at 22:51

@freeformz damn that’s a huge enclosure. Very nice

=> More informations about this toot | More toots from whack@hachyderm.io

Written by Shawn Wilsher on 2025-01-03 at 20:00

@freeformz I was considering using https://www.printables.com/model/742061-prusa-xl-air-seals to help seal it up better

=> More informations about this toot | More toots from sdwilsh@social.ridetrans.it