Ancestors

Written by Anton Piatek on 2024-12-21 at 14:36

Any #3dPrinting #Makers have any experience of clay/stone filament? Have had failures using formfutura stonefil as its building up on my extruder gears and ends up just wearing out the filament and not feeding. Other than slowing the print speed, should I loosen the idler springs too? Any other tips? (have a 12hr print to try and make work, failed halfway yesterday)

=> More informations about this toot | More toots from sldrant@mastodon.social

Written by Greg on 2024-12-21 at 15:20

@sldrant I had no idea one can print clay/stone. I presume they need firing afterwards though?

=> More informations about this toot | More toots from gregalotl@c.im

Toot

Written by Anton Piatek on 2024-12-21 at 15:32

@gregalotl no it's 50% clay/stone in pla filament. Just having some issues on longer prints. https://formfutura.com/product/stonefil/

(there are also ones you can fire, but they're totally different)

=> More informations about this toot | More toots from sldrant@mastodon.social

Descendants