Für ein Projekt möchte ich einen Raspi und paar Zusatzbauteile (USB-Hub, externe SSD und so) in ein Gehäuse verfrachten, und die relevanten Anschlüsse mit verschraubbaren Terminals nach außen verlegen.
Was für ne Art Gehäuse würd sich da anbieten? Hätte erst an so ne normale graue Elektro-Installationsbox aus dem Baumarkt gedacht, aber da ist das mit dem Airflow evtl schwierig. Was selbstgedrucktes? Was nutzt ihr für sowas?
=> More informations about this toot | More toots from ttk@ruhr.social
@ttk Würde mittlerweile, wo das nicht mehr peinlich nach Wurststapeldruck aussieht, selbst ein Gehäuse zusammendesignen und “drucken”.
=> More informations about this toot | More toots from nblr@chaos.social
@nblr mal sehen ob ich so gut onshape kann mittlerweile 😁
=> More informations about this toot | More toots from ttk@ruhr.social
@ttk Danach kannstes auf jeden fall besser!1
Bei vielen CAD-Dingen die letzten Monate festgestellt: Puh… das hat jetzt länger als nötig gedauert. Wenn ich gewusst hätte, dass das so lange dauert, hätte ich das nicht gemacht. Das nächste mal dauerts aber nicht mehr so lange.
=> More informations about this toot | More toots from nblr@chaos.social This content has been proxied by September (3851b).Proxy Information
text/gemini