Ancestors

Toot

Written by Joe Kaufeld on 2024-11-26 at 19:12

@jacqueline Hey, if I'm printing a Tangara case, should I be using PETG or ABS? Is there a preference as far as you're concerned?

=> More informations about this toot | More toots from itsthejoker@fosstodon.org

Descendants

Written by jacquelines 🌟 on 2024-11-26 at 20:46

@itsthejoker either should be fine, so long as u can print it well. i have awful luck with abs but maybe you're built different!

=> More informations about this toot | More toots from jacqueline@chaos.social

Written by Joe Kaufeld on 2024-11-26 at 21:01

@jacqueline I have a good setup for it, so it's mostly about "what will fare better over time" 😄 I'm making a quad lock-compatible back STL so that I can mount the unit in my car. I'm really excited about this ^_^

=> More informations about this toot | More toots from itsthejoker@fosstodon.org