Almost done with this l-match #hamradio antenna tuner. I tried to put it into a case since it was a known circuit, which went predictably poorly. After I splayed it out onto a blank copper board (like I should've done in the first place), it became much easier to find the problems.
The final version is in a different case, using a different coil setup, but, most importantly: using copper tape as "bus bars" worked really well. Would recommend as a technique, if you're low power enough.
=> View attached media | View attached media
=> More informations about this toot | More toots from xek@hachyderm.io
text/geminiThis content has been proxied by September (3851b).