Ancestors

Written by Chad Hill on 2024-11-15 at 06:19

Well, that’s ALMOST all the top sensors installed: lidar, rotary encoder, light sensor, 2x OLEDs, accel/gyro. Just missing the position sensor for the lens rangefinder cam. Thats a lot of electronics gear in a DIY camera.

I realllllly hope this works. 😄😅

[#]CameraGear #MenderReveal #DIYCamera #IdentifemMRF

=> View attached media

=> More informations about this toot | More toots from ChadHillPhotos@mastodon.art

Written by Billthoo on 2024-11-15 at 06:27

@ChadHillPhotos the range finder isn’t coupled, is it, Chad?

=> More informations about this toot | More toots from Billthoo@mastodon.art

Written by Chad Hill on 2024-11-15 at 06:45

@Billthoo it IS! This camera is bonkers.

There is a position sensor that reads the rangefinder coupling on the lens. All the UP lenses are pre programmed AND there is a calibration process to fine tune it.

Display in the viewfinder shows a traditional (sort of) moving reticule to indicate focus, And shows text of current lidar measurement and current lens focus distance. Also shows light meter info (and a whole menu system) all in the viewfinder!

I’m so impressed by everything on this.

=> More informations about this toot | More toots from ChadHillPhotos@mastodon.art

Written by Billthoo on 2024-11-15 at 06:49

@ChadHillPhotos Oh. My. Goodness!!!

=> More informations about this toot | More toots from Billthoo@mastodon.art

Written by Chad Hill on 2024-11-15 at 06:54

@Billthoo the heads up display also shows a horizon because it has an accel/gyro sensor. 😅

All the data is there so that the overlay mask COULD also move the frame to compensate for parallax depending on focus distance. It doesn’t currently do that, but I’ve talked to the designer about adding it.

After fitting all the components tonight I am feeling super optimistic about being able to complete it. The build instructions are very good and the design is so well thought out.

=> More informations about this toot | More toots from ChadHillPhotos@mastodon.art

Written by Billthoo on 2024-11-15 at 07:01

@ChadHillPhotos wow! I did not expect that!

=> More informations about this toot | More toots from Billthoo@mastodon.art

Written by Chad Hill on 2024-11-15 at 07:07

@Billthoo yeah, i could not resist trying to build this. It’s so much more camera than any of the other cameras I’ve printed.

If you didn’t see where I posted it below, check out the video intro by the designer here: https://www.instagram.com/reel/C63eiv-o6UP/?igsh=MTc2aTZtcGdieGhpYQ==

He also has a bigger version: a coupled rangefinder 4x5 and a better demo of the focusing in the viewfinder: https://www.instagram.com/reel/C4gL02moCqT/?igsh=MWQxbG1qeTJrZ2U2eQ==

=> More informations about this toot | More toots from ChadHillPhotos@mastodon.art

Toot

Written by Keith Devereux on 2024-11-15 at 07:42

@ChadHillPhotos @Billthoo ... A bit late to this. Saw your posts about building a 3D printed camera, but that's astounding!

=> More informations about this toot | More toots from keithdevereux@mastodon.art

Descendants