Ancestors

Written by Archiviste Dragontigre on 2024-10-02 at 16:26

I'm printing a thing... so I will paint again, relatively soon.

=> View attached media

=> More informations about this toot | More toots from Archiviste_Dragontigre@tabletop.social

Written by Archiviste Dragontigre on 2024-10-03 at 16:27

Breeding turtles at the local fablab.

[#]TMNT

=> View attached media

=> More informations about this toot | More toots from Archiviste_Dragontigre@tabletop.social

Written by Archiviste Dragontigre on 2024-10-08 at 15:58

Experimenting with acrylic gesso, applied with a brush, as primer on FDM 3D prints (in PLA).

On the left: one coat of black, on the right: left half = 1 coat of white, right half = 2 coats.

I've probably been a little shy on the first coat of white. And I can learn to apply that gesso better. But 2 coats of white are probably a minimum.

[#]MiniaturePainting

=> View attached media

=> More informations about this toot | More toots from Archiviste_Dragontigre@tabletop.social

Written by Archiviste Dragontigre on 2024-10-09 at 19:36

Another PLA turtle primed. This one with a cheap sprayed grey primer.

=> View attached media

=> More informations about this toot | More toots from Archiviste_Dragontigre@tabletop.social

Toot

Written by Archiviste Dragontigre on 2024-10-11 at 16:05

Well... at least we tried.

That cheap UV Resin did not make miracles. It is quite obvious once covered with grey primer.

Honestly, I don't see much difference with the one on which we only used the primer.

And that sh*t is a pain to clean.

=> View attached media

=> More informations about this toot | More toots from Archiviste_Dragontigre@tabletop.social

Descendants

Written by Archiviste Dragontigre on 2024-10-13 at 15:48

[#]MiniaturePainting

I painted one of our test subjects.

3D printed #TMNT Leonardo bust.

Original file: https://www.thingiverse.com/thing:4072006

=> View attached media

=> More informations about this toot | More toots from Archiviste_Dragontigre@tabletop.social